| Age | Commit message (Collapse) | Author |
|---|
|
In d0478c41f432 ("libcamera: Rename "shutter speed" to "exposure time"")
the tuning file entry "shutter" was renamed to "exposure-time". As the
tuning files use camel cased key names, change "exposure-time" to
"exposureTime" for consistency. It doesn't break our users setups as
there are no tuning files using that entry in the wild (at least
officially).
Signed-off-by: Stefan Klug <stefan.klug@ideasonboard.com>
Reviewed-by: Daniel Scally <dan.scally@ideasonboard.com>
Reviewed-by: Kieran Bingham <kieran.bingham@ideasonboard.com>
|
|
The terms "shutter" and "shutter speed" are used through libcamera to
mean "exposure time". This is confusing, both due to "speed" being used
as "time" while it should be the inverse (i.e. a maximum speed should
correspond to the minimum time), and due to "shutter speed" and
"exposure time" being used in different places with the same meaning.
To improve clarity of the code base and the documentation, use "exposure
time" consistently to replace "shutter speed".
This rename highlighted another vocabulary issue in libcamera. The
ExposureModeHelper::splitExposure() function used to document that it
splits "exposure time into shutter time and gain". It has been reworded
to "split exposure into exposure time and gain". That is not entirely
satisfactory, as "exposure" has a defined meaning in photography (see
https://en.wikipedia.org/wiki/Exposure_(photography)) that is not
expressed as a duration. This issue if left to be addressed separately.
Signed-off-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Reviewed-by: Naushir Patuck <naush@raspberrypi.com>
Acked-by: Kieran Bingham <kieran.bingham@ideasonboard.com>
|
|
With the addition of gamma out correction the relative luminance target
was set too low. As brightness is a bit subjective it is difficult to
come up with the "correct" value. With 0.5 the patch 22 on the macbeth
chart (neutral grey, 18% reflectance) ended up a bit below 50% grey,
which seems reasonable.
Signed-off-by: Stefan Klug <stefan.klug@ideasonboard.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Reviewed-by: Paul Elder <paul.elder@ideasonboard.com>
|
|
Add a skeletal AGC module just so that we can have some AGC tuning
values that we can use to test during development of AGC in the IPAs. As
rkisp1 is the main target, we only add support for rkisp1 for now.
The parameters are mostly copied from the hardcoded values in ctt,
except for the metering modes.
Signed-off-by: Paul Elder <paul.elder@ideasonboard.com>
Reviewed-by: Stefan Klug <stefan.klug@ideasonboard.com>
Reviewed-by: Kieran Bingham <kieran.bingham@ideasonboard.com>
|
